Comments

You must log in or register to comment.

SolidPoint t1_iy0gvtp wrote

I do not recommend working with gas with zero experience.

4

spiderskizzles OP t1_iy0hyjc wrote

I do have non-zero experience. Regardless I'm not really asking for advice on how to work with gas. I'm asking for an idea of what I need to be looking for to get this fireplace running. Even if I hire a plumber (and I probably will), I will still have to buy a fireplace set, and I have no idea what to buy, or even begin to look at prices, or anything.

−1

liquidbluenight t1_iy0er5b wrote

Whatever you do, please be sure to install at least one, ideally several working carbon monoxide (CO) detectors in your home. Gas fireplaces that aren’t vented correctly or that don’t burn off the fuel properly can produce carbon monoxide which is odorless, tasteless, colorless - essentially not detectable without specialized machinery - and can kill you or anyone in the home within minutes.

3

Syndicofberyl t1_iy0l47s wrote

You call an hvac technician. No offense but you don't know what you're doing. You will likely kill people dicking around with gas.

2

spiderskizzles OP t1_iy0lpjy wrote

I'm not really dicking around with gas. I'm looking for advice on how to order parts for a fireplace. I'm not going to pay someone to tell me what kind of fireplace I need to buy when someone on reddit can point me in the right direction. If it's more complicated than that, you should tell me why, otherwise I will just be guessing at what I'm doing. That is much more likely to cause the outcome you are concerned about.

−1

Syndicofberyl t1_iy0s9q5 wrote

I used to do hvac as an assistant. There's lots of thought that goes into an install.

What's your chimney liner like? Do you have a chimney liner? Is the interior of your chimney collapsed? Can you accommodate a direct vent setup? Do you have electricity at the fireplace? Is that gas line even still connected?

The previous owners removed the insert for a reason. Finding out why is a good step.

This is why you call a gas tech. They can come by and for a small fee give you an idea of whether or not your setup is workable, or if it's not. You strike me as someone who likes to save money and if you've gotta replace the chimney, that's not cheap and not to be done by amateurs. Further, the majority of insurance companies will fuck you sideways if you so much as breathe on a gas appliance without being licensed.

2

A_Plumber2020 t1_iy0n2ep wrote

There are many companies that specialize in fireplace installation. Plumbers can move the gas lines, replace valves etc... but the fireplace company can provide you with the appropriate equipment and perform chimney/vent inspections (which is definitely a good idea with something that hasn't been used in a while).

2

chopsuwe t1_iy0q262 wrote

Your submission has been removed for one or more of the following reason(s):

  • You're asking what product or tool to buy.
  • You're asking about the features, properties or capabilities of a product or material made by someone else.
  • You're asking where to buy a product or tool.
  • You're asking for suggestions for a product or tool you intend to buy.

We do not permit posts asking for suggestions on materials and tools. This is because of spam.

  • /r/DIY is focused on the how, what technique to employ and which tool to use.
  • If you need recommendations for a product, you'll probably have better luck in a more specialised subreddit, e.g. /r/HomeImprovement, /r/woodworking, r/helpmefind, etc.

Please read our Full Sub Rules before resubmitting.

If you believe this was a mistake, please message the moderators.

###Do not respond to this comment - you will not receive a response.

1