GeekX2 OP t1_jdjdbk3 wrote
Reply to comment by [deleted] in Recirculating pump for tankless water heater by GeekX2
The ones I've looked at require 240V which would be a bigger deal. And would only fix the problem in one fixture.
fredsam25 t1_jdjosot wrote
If you get one with a small tank for the kitchen sink, it can run off 120v. It'll be a heck of a lot more efficient than constantly recirculating.
For the bath as well, if you add a ~2.5 gallon 120v water heater in line with with hot water line, it'll give you hot water long enough for the water from your main water heater to arrive.
Wellcraft19 t1_jdkdc2z wrote
This is the right answer ☝️
[deleted] t1_jdjh53t wrote
Personally, I would rather run the electric (assuming there's space in the breaker box) then deal with new plumbing.
I did misunderstand your post though. I thought that the kitchen was your main focus. Even if you are concerned about more than one fixture I would still strongly consider the point of use heaters. Or get rid of the tankless heater.
I probably wouldn't end up doing any of this. None of these options make good financial sense...but not everything we do in life needs to be the sensible thing.
GeekX2 OP t1_jdjhv2g wrote
Keep in mind that I would have the same problem with a tank water heater. That is, it takes a long time to get water at the fixture.
Space in the box is a concern.
[deleted] t1_jdjihse wrote
Right, but tankless+recirculation is a nonstarter in my mind. Your options are tankless and point of use on key fixtures or tank and recirc.
Viewing a single comment thread. View all comments