[removed]
Comments
rizz_explains_it_all t1_jdffv63 wrote
Are toggle bolts made for drywall or plaster? The instructions said to only drill into a wooden stud or concrete. Sorry I’m a novice.
arethius t1_jdfhpbo wrote
Yes they will work as long as you aren't using a full motion or cantilevered mount. If it's a fixed position or tilt bracket, toggle bolts will be more than sufficient
rizz_explains_it_all t1_jdfhy5m wrote
Ah I see, it does have more motion so I might combine what you and another reply said and toggle bolt some wood. Thanks!
TootsNYC t1_jdg3yzq wrote
use the zip toggle / snap toggle / Toggler version of toggle bolts instead of the spring-loaded ones. The Toggler version are easier to deal with.
Toggle bolts can go behind the lathe and plaster or the drywall; they expand inside the wall cavity.
Quiet--Thoughts t1_jdfaks4 wrote
You could try adding a 2x4 or 2x6 to the wall of the closet by using a few wall anchors or toggle bolts. Make sure it's secured firmly to the wall before attempting to mount your TV. A frame inside the closet is probably not necessary, but you may want to consider doing so depending on the weight of your TV. Good luck!
rizz_explains_it_all t1_jdfi5t6 wrote
Thanks so much, I really didn’t want to have to build a frame haha. I will look into toggle bolts and I think as long as the wood is touching the floor and bolted in it should be good?
SamBrico246 t1_jdgb4o9 wrote
Toggle bolts spread the load to secure onto a sheet of plaster or drywall.
In your case, you could go a tep further and use a peice of wood as your anchor. You wouldn't really need to secure the wood to anything, the TV bolts would hold it in place.
It might be overkill, but would be more secure then toggle bolts alone, but does require drilling straight through the wall producing holes in the closet to patch and paint when you leave
crabapplesteam t1_jdhqb5z wrote
Your submission has been removed for one or more of the following reason(s):
- Your question does not include the research you've done to find an answer yourself, or why that research didn't answer your question.
This is a basic requirement so others do not spend time repeating your steps. It is not a judgement about your question being "too easy." We're looking for evidence that you've made an attempt yourself.
-
Please do not use /r/DIY as your first stop for questions - we are not Google.
-
Please search Google and /r/DIY to see if your question has been asked before. Check owners manuals, tech support forums or contact the manufacturer.
-
Have you already done some basic research and are still stuck?
-
Please include what research you have done in your question so that others do not repeat your steps.
-
Consider posting your question in the sticky thread at the top of the subreddit.
-
Ask your question in our Discord server in the appropriate channel.
Please read our Full Sub Rules before resubmitting.
If you believe this was a mistake, please message the moderators.
###Do not respond to this comment - you will not receive a response.
Sometimes_Stutters t1_jdfc8r0 wrote
So you’re going to fasten the TV mount with like 8” screws?
rizz_explains_it_all t1_jdfcxqx wrote
The screws that came with the mount are 2.1” but I could get longer ones if needed.
Good_Ad4759 t1_jdffkwp wrote
You could use toggle bolts, they are bolts with a spring loaded but attached that are used for exactly this type situation. Four 1/4” toggles should easily hold a TV.