where/how to find narrow washers Submitted by lemlurker t3_yidaht on October 31, 2022 at 2:11 PM in DIY 8 comments 1
Outside_Advantage845 t1_iui1s9e wrote on October 31, 2022 at 2:23 PM Can you not bore out the m6 center with a properly sized drill bit? Permalink 1 lemlurker OP t1_iui2df0 wrote on October 31, 2022 at 2:27 PM Figured reliably doing that without it biting given the low grip area would be very difficult Permalink Parent 1
lemlurker OP t1_iui2df0 wrote on October 31, 2022 at 2:27 PM Figured reliably doing that without it biting given the low grip area would be very difficult Permalink Parent 1
Viewing a single comment thread. View all comments