Submitted by TheRealBeakerboy t3_ygrjec in DIY
TheRealBeakerboy OP t1_iuahhtb wrote
Reply to comment by some_kind_of_rob in Workbench drawer pulls made from hex bolts. by TheRealBeakerboy
That’s not a bad idea. Drill a large hole and install some tee nuts and then screw some stubby bolts into the tee nut. Probably would have to use some Epoxy on the threads to prevent them from screwing in and out
Emergency-Wave-5335 t1_iudn1gu wrote
>stubby bolts
"Threaded rod" 😁
TheRealBeakerboy OP t1_iudnxld wrote
By stubby bolt, I meant more like a 1/2”x1” or something. Thread a little into the wood and leave the hex head as the part you grab.
Emergency-Wave-5335 t1_iudppuw wrote
Ooohhh sry
Viewing a single comment thread. View all comments