TheRealBeakerboy OP t1_iuf26ml wrote on October 30, 2022 at 8:58 PM

Reply to comment by SnowFlakeUsername2 in Workbench drawer pulls made from hex bolts. by TheRealBeakerboy

I basically did that on the threaded end. I used a dremel to grind down the threads so the centering bit has more area to grab.

SnowFlakeUsername2 t1_iuf4umd wrote on October 30, 2022 at 9:16 PM

For sure. I was more so thinking that the standoffs are flat where it contacts the bolt when screwed in. If both surfaces are flat where they meet than it resists twisting better than a flat surface meeting a rounded one. Maybe it doesn't really matter for a door pull.