Viewing a single comment thread. View all comments

FredPolk t1_j2e25th wrote

The jets would be the hose going into the stand pipe, not through the valve. The dye you put in the water bowl goes through the flush valve and into the bottom. The rim jets are fed from the hose coming off your valve. Check to see if that hose is leaking.

45

FredPolk t1_j2e2mw0 wrote

…also make sure the tank level is adjusted correctly. If it is set too high, it will go down that same overflow pipe and come out the rim jets. After flushing and stopping the fill, it should be at least a 1/4” below that stand pipe.

23

Aqueousfun OP t1_j2e8w3m wrote

Nonissue there, water level is about a half inch below lip of overflow pipe.

3

Aqueousfun OP t1_j2e8sqs wrote

Last night I actually pulled the hose out of my he stand pipe to make sure that wasn’t the issue. Water still dribbles from the jets unfortunately

5

Rcarlyle t1_j2fne88 wrote

If the refill hose is stuck down the overflow tube too far, it will continuously siphon a trickle of water into the bowl.

9