Viewing a single comment thread. View all comments

Suyneej t1_j242vdn wrote

You'll be good. The sink rests on the countertop itself and that is where it gets support from. The flange just holds it in place from moving side to side (once you tighten the brackets under the countertop) and covers the hole you've cut in the countertop for the sink.

and you are correct about swapping hole saws for each material.

−5

Own-Pea-8212 t1_j24arlf wrote

OP stated that it’s an undermount sink which, by definition, means the sink does not rest on the countertop because it is underneath the countertop and not on top of it.

6