Viewing a single comment thread. View all comments

5degreenegativerake t1_j37zu1p wrote

I assume you know what a spring form pan is? You could make your own “rings” like a spring form pan using stainless steel shim stock. The shim stock is flat and you can cut it with good scissors, then roll it up and secure it with a piece of wire or something around the outside.

1

Greg_Esres OP t1_j38198e wrote

I thought about something like this, but didn't know what to look for. Shim stock? Half of life is knowing what to Google on.

And I wasn't sure how to close the ring. I do have a MIG welder, but never got around to assembling it.

1

5degreenegativerake t1_j383qy9 wrote

Yep. Amazon has lots of shim stock options. You probably want to be at 0.01in (0.25mm) thick or less to make it easier to cut.

I would just wrap the outside with stainless steel wire and twist the end like a bread tie.

2