Viewing a single comment thread. View all comments

_KJuns t1_irqya8h wrote

Reply to comment by _KJuns in Keychron q1v2 by One_Macaroon1592

Sorry - I sometimes have to edit some stuff, but now it should be readable.^^ I'm german if that's a language you would prefer.

1

One_Macaroon1592 OP t1_irr0580 wrote

No need to worries, now I get what u mean, last question is the max height of the silicon sheet is 0,5mm for don't touch the pcb or can in go with 1mm?

Ps: I'm Italian so German is gonna be worse than English ahah

2

_KJuns t1_irr1h92 wrote

I think so, yes: In my case, Q1V1, 1mm is just thin enough, but I think in your case, Q1V2, 0,5mm is the way to go (because of what I stated in my first post). Or you test it without any silicone at all before you search and buy one. There is a chance you do not need it at all, because your extended force break takes care of the ping-issue by itself. And your tape mod saves you from a short.

1

One_Macaroon1592 OP t1_irr3cwd wrote

Ok thank you a lot dude, I will try next week , and update here. Have a good day👍

2