zemsten t1_j4t7qs2 wrote
Reply to comment by SharkAttackOmNom in If nuclear fission in U-235 causes the atom to be split into 2 smaller atoms (such as Kr-92 and Ba-141) then how is it that U-236 is produced as waste since the U-235 was just split into smaller peices? by Ian98766
This is due to the temperature of the moderator (water) though, isn't it? At least mostly? This is important because a fast neutron has a higher probability of slowing down through water as a moderator when that water is more dense. More slowing down -> more thermal neutrons -> higher likelihood of a thermal fission. Fast fissions are negligible except for during source range reactor startups.
SharkAttackOmNom t1_j4tfd7x wrote
Yes when referencing the negative temperature coefficient, that’s the water (and in general the heat of the whole core) which lowers reactivity due to inefficient neutron-slowing. The effect is even more pronounced of the water is allowed to boil to steam. The steam bubbles making “voids” which won’t slow neutrons, basically at all.
Neat trick can be played here. Thermal output can be controlled in a BWR reactor by increasing or decreasing the coolant flow. Faster flow will drive the threshold of boiling water higher, allowing more of the fuel rod to fission. If they want to slow the reactor, slow the coolant flow rate. The water will boil lower and reaction rate slows at the top of bundles. BWR control rods insert from the bottom so it can control reaction rates from bottom up and top down.
Viewing a single comment thread. View all comments