Viewing a single comment thread. View all comments

P1xelHunter78 t1_j927klm wrote

Reply to comment by ecksate in Scientists have figured out a way to engineer wood to trap carbon dioxide through a potentially scalable, energy-efficient process that also makes the material stronger for use in construction by giuliomagnifico

Or, stronger wood in traditional stick built houses wouldn’t be awful

179

darga89 t1_j93zhjp wrote

> Or, stronger wood in traditional stick built houses wouldn’t be awful

yeah right, they'll just increase stud spacing and reduce sheathing thickness with any new tech advances.

69

bigdaddyborg t1_j943zbv wrote

Increasing stud spacing (without compromising structural strength) would actually help with getting residential buildings closer to a carbon neutral life-cycle. As it would reduce thermal bridging and make homes easier/cheaper to maintain a healthy internal temperature.

49

poplafuse t1_j9467ud wrote

The more studs the hotter it gets if ya know what I mean

28

dmattox10 t1_j941sz1 wrote

This person is correct, simulations allow for much more accurate information on how to build, which has made boats for example more fragile in the same way. They used to use much much more fiberglass than they do now that we fully understand it’s strength.

16

altiuscitiusfortius t1_j963s8r wrote

My house was built in 1929 using old growth lumber by somebody who didn't know how how strong to build things, and it was overbuilt so much I could park a tank in my living room.

Literal tree trunks for beams that are so dense I can't pound a nail in to them. The "2x4s" for framing walls measure 3inches x6 inches. The subfloor isn't thin plywood, its 3x12 inch planks

3

danielravennest t1_j97a51j wrote

On the other hand, one old house I lived in needed concrete floor support jacks in the crawl space because the floor joists were too weak on their own. They just didn't have standards and building inspectors back then.

On the other hand, when I renovated, I found the wall studs were actual 2x4s, not 1.5x3.5 like modern ones. But they were rough cut, right from the sawmill.

1

TheIllustrativeMan t1_j98b379 wrote

2x4 refers to the rough cut dimensions, so that's why. Modern studs are "finished 4 sides", which decreases the dimensions after rough cut.

2

Kaeny t1_j951w5a wrote

I want to live in one of those japanese traditional towers. Like for the nobles

2