Blackoutsmackout t1_j6jtsro wrote on January 30, 2023 at 9:01 PM

Reply to Would you say that you identify more with NJ or the US as a whole? by mszanka

I don't care if it's called taylor ham or pork roll so whatever that makes me.

Blackoutsmackout t1_j6jrxfd wrote on January 30, 2023 at 8:50 PM

Reply to comment by amoore031184 in How do I prevent condensation on the windows from causing water to accumulate on the windowsill? by teddythepooh99

I used tape and plastic on a window like this, solved the issue.

Blackoutsmackout t1_j6fx6r2 wrote on January 30, 2023 at 1:21 AM

Reply to How do I remove a stuck bolt holding my bike's kickstand in place? by S_Orbital

You might be able to take the wheel and fender off, rock and wiggle the kickstand backwards then twist the top piece counterclockwise 90 degrees with a vise grip and have it drop out.

Blackoutsmackout t1_j6fwhgy wrote on January 30, 2023 at 1:16 AM

Reply to comment by GoodGoodGoody in How do I remove a stuck bolt holding my bike's kickstand in place? by S_Orbital

If you are going to start off by saying nobody has a clue about bike repair here i'm going to ask about one of your suggestions. Do you really think a drill with a left handed bit will get into the space available behind the seat tube?

Blackoutsmackout t1_j2c5uar wrote on December 31, 2022 at 3:54 AM

Reply to comment by fizz306 in Got pulled over for tints today(on 287). Showed the trooper this and he sent me on my way, saying it’s the first time he’s ever seen one by JCisnotNYC

Ya this guy was in front of me at a stop light...LE plate black all around. sitting at the green for 5 seconds probably sending important police texts.

Blackoutsmackout t1_j2bgjna wrote on December 31, 2022 at 12:41 AM

Reply to comment by 5degreenegativerake in Stripped Swing Set Lag Bolts by elpuppetmaster

Ok well they need something to grip maybe drill a 1/4" hole alongside the lag then hammer in a 1/4 dowel so the lag can grip and pull itself out.

That or try to find out where they would come out the backside, use a forstner or something to find the tips and push them out while spinning them.

Drill and tap the head for a 10-24 2" bolt. throw a tack weld on them cut the head off the bolt, close a drill chuck on it and spin it in reverse and pull.

Drilling things out like this is a PITA, you'll never get it right and by the time you are through the hole will be 3/4" from the drill wandering all over.

Blackoutsmackout t1_j2bczj3 wrote on December 31, 2022 at 12:15 AM

Reply to comment by kai_ekael in Stripped Swing Set Lag Bolts by elpuppetmaster

i'm saying a 6" long core bit. Core out the whole lag after popping the head off.

Blackoutsmackout t1_j2b6eg9 wrote on December 30, 2022 at 11:28 PM

Reply to comment by ThisIsJustForPornog in Stripped Swing Set Lag Bolts by elpuppetmaster

Good luck driving straight through the entire bolt. I'm looking to see if a long 1/2" or 3/4" core bit exists. core the whole thing out, can't find any, maybe a diamond bit with slots cut in.