Templar42_ZH
Templar42_ZH t1_iwefecd wrote
Reply to Please help me identify how this profile was cut, I need to essentially replicate the piece of rotten wood by whippets
Flush cut router bit with a bearing. Either top or bottom mount can work just make sure the bearing rides against the rotten wood to guide. Likely will need to clean up those corners, grab your pull saw for that.
Templar42_ZH t1_iwfo0te wrote
Reply to comment by whippets in Please help me identify how this profile was cut, I need to essentially replicate the piece of rotten wood by whippets
All is not lost! Both of these are produced by a router bit. Well, two different bits but still. Due to a combination of beer league hockey and alcohol I am currently unable to find the bits you need. Hopefully someone else will swoop in and take the assist.