Waltzing_With_Bears t1_j29z1ls wrote on December 30, 2022 at 6:43 PM

Reply to comment by Larechar in Building a work bench: wood screws or lag bolts? by CaptInsane

Anything is good with enough butter and salt

Waltzing_With_Bears t1_j279ydm wrote on December 30, 2022 at 3:51 AM

Reply to Building a work bench: wood screws or lag bolts? by CaptInsane

Theres a good Stumpy Nubs video about making a woodworming bench, Id take a look at that for some ideas

Waltzing_With_Bears t1_ix7lbwx wrote on November 21, 2022 at 10:37 AM

Reply to What is the called of that set of pre-measured metal bars that are usually used as a reference to calibrate, for example, the height of the bench saw? by Pretty-Information53

Guage blocks perhaps

Waltzing_With_Bears t1_iwq2o89 wrote on November 17, 2022 at 2:38 PM

Reply to comment by Wooble_Gopp in I am taking apart a small engine, and wondered how I should label the bags I am placing screws in. by Wooble_Gopp

And be certain to get the lay out of the head bolts right, and check the manual for installation order, if ya do it wrong it can cause trouble with gasket sealing

Waltzing_With_Bears t1_iw2vsl3 wrote on November 12, 2022 at 3:20 PM

Reply to DIY project ideas for hair dryer by hurly_burly_pegasus

Could pull it apart and do a shadow box with the components in an exploded view

Waltzing_With_Bears t1_iujvccl wrote on October 31, 2022 at 9:48 PM

Reply to Does longer Ethernet cable make a difference? by Pure-Fold-5717

Yes but no, technically it can but not at lengths you can buy from a store

Waltzing_With_Bears t1_iuhr324 wrote on October 31, 2022 at 1:00 PM

Reply to How to account for small hearth height difference when laying floating wooden floor? by MotionBlyr

Honestly I would just leave it, your hearth being a little high isnt a problem, unless its really bothering you, in which case you could get some slightly sloped tiles (or flat ones and use a bit of filler) and make it stand out a little more, or use some bricks or similar