afgunxx
afgunxx t1_j1z0h6c wrote
For the rear 2 legs you could do an X crossbrace between them. Metal, and you can use tools to bend it to the shape of the legs. Connect in the center where they cross for additional stability.
For the front 2 legs, consider using flat metal straps and screw in to the bottom of the legs; no bar to raise the chairs over, just a small metal strip.
If my ideas don't make sense, LMK.
afgunxx t1_j1uxir8 wrote
Under that red spot will be a (most likely allen headed) set screw.
afgunxx t1_j1zccl4 wrote
Reply to comment by DoingItLeft in Easy and cheap way to reinforce my table legs to avoid wobble by No-Awareness-1834
You want something rigid enough that it won't bend under mild stress; pipe hanger metal might. More like flat bar (hardware stores sell that too).