I have a couple - no Enders - but I’ve been printing for a few years. Currently building a new Voron 2.4 now. Anyway, when you lose a print, what’s happening? Are you losing adhesion, or is it layer separation? What calibrations have you done so far? Assuming PLA - have you printed a temp tower? What bed temp are you running? Putting anything down for increased adhesion?
engco431 t1_j7eiprv wrote
Reply to 3D Printer, Looking for 3D Printer guidance by The_Kings_Goblet
I have a couple - no Enders - but I’ve been printing for a few years. Currently building a new Voron 2.4 now. Anyway, when you lose a print, what’s happening? Are you losing adhesion, or is it layer separation? What calibrations have you done so far? Assuming PLA - have you printed a temp tower? What bed temp are you running? Putting anything down for increased adhesion?
There are lots of questions. More info will help.