fuzzybear3965

fuzzybear3965 OP t1_j7591zg wrote

Yeah, mine is flat, not beveled. I guess I just meant that the arrangement of components in that picture reminded me of my solution - my gasket/washer is shaped differently, though, you're right.

That's why I didn't even think to slide it over the neck. Even when I tried it I was worried it would tear. But, the material is pretty strong (I had to remove and attach it a couple of times because of wrong order of events) and it really snugs in tight. So, even though it's flat and thin I think it's the ticket.

2

fuzzybear3965 OP t1_j756ub2 wrote

I think I solved it. The trick was to slide one of the gaskets (the white one) over the neck of the tube. The green gasket goes between the top of the tube and the base of the pipe coming out of the base of the sink. The white gasket forms a pressure fit between the female-threaded collar and the male threaded catch.

It's all assembled and everything's tight. I ran the sink for 20 minutes just to be sure. It took me two hours of trying every combination of attachments but I think it's solved.

3