Can I use a table saw to make this cut? Submitted by [deleted] t3_11fbg6s on March 1, 2023 at 6:35 PM in DIY 14 comments 0
bluehat9 t1_jaip8zo wrote on March 1, 2023 at 6:46 PM You could make an angled jig for your table saw track and you could make the cuts about 99% of the way and finish with a hand saw to avoid the over cut underneath. You could put a stop block to stop the wood from going too far on the saw Permalink 3
Viewing a single comment thread. View all comments