Viewing a single comment thread. View all comments

[deleted] t1_ixzl1ej wrote

[removed]

5

Jak_n_Dax t1_ixznbc0 wrote

A $20 Harbor Freight angle grinder with $5 in cutting wheels will do the job 3x as fast and with 1/2 the effort.

2

zedsmith t1_ixzplik wrote

I mean— minus the whole driving to a harbor freight part. OP already has a hammer.

My solution is free, and as a tip it’s generalizable, and something a lot of people don’t know— if you blow through trim with an 18 or 15 gauge brad, bending the nail back and forth until it snaps is a lot less destructive and easier than trying to back it out with a set and hammer.

2

[deleted] t1_ixzlcbr wrote

[removed]

1

zedsmith t1_ixzlifh wrote

Jesus Christ. 😂

“The nail will break beneath the plane of the floor”

Leaving the original up for posterity

3