nicolas_33 OP t1_jedyjv0 wrote on March 31, 2023 at 9:37 AM

Reply to comment by VXQN in TX-Stabs disappointment by nicolas_33

Yes I used those little plastic pieces. But they had a snug fit in the PCB anyway.

I really don’t have a clue what was going on there. I have read a few reports from people being disappointed and people being really fond of them. That is weird. Maybe there are different batches / different tolerances for the 1.2 vs the 1.6mm variant?

MayAsWellStopLurking t1_jedz09b wrote on March 31, 2023 at 9:43 AM

What keyboard were you putting them in? Sounds like it’s a 1.6mm PCB.

Edit: if Staebies fit perfectly then your PCB is 1.6mm because I’ve not seen 1.2mm variants. So you tried putting stabilizers meant for PCBs .4mm thinner than the one you have.

nicolas_33 OP t1_jedz4s4 wrote on March 31, 2023 at 9:45 AM

Akko ACR 75 Top which has a 1.2mm PCB.

MayAsWellStopLurking t1_jedzdhz wrote on March 31, 2023 at 9:48 AM

Can you take a photo of an extra Staebies housing next to the TX one?

nicolas_33 OP t1_jedzx1g wrote on March 31, 2023 at 9:56 AM

I don’t have any extra Staebies housings left to take a picture of.

nicolas_33 OP t1_jedzeco wrote on March 31, 2023 at 9:49 AM

I put shims below the Staebies ;)