HIM101
HIM101 OP t1_j54dyp5 wrote
Reply to comment by gladeyes in What container for DIY pressure pot for 5-10 PSI by HIM101
Thanks for this tip. Ill tty to see if I can find anything like that, though ive found finding proper pvc pipes is bothersomely difficult. If i can find any ill go for it, but if not ill still keep the water tip. And yeah ill avoid glass, much appreciated
HIM101 OP t1_j54du7z wrote
Reply to comment by snarkycouple in What container for DIY pressure pot for 5-10 PSI by HIM101
Not american, we dont have that store. As for cheap even the cheap ones around whwre i live seem to be around 35-40 euro. Beside that do they work for casting epoxy? I couldnt find a clear answer
HIM101 OP t1_j548hmk wrote
Reply to comment by MacsGPPDisorder in What container for DIY pressure pot for 5-10 PSI by HIM101
It doesnt have to be glass. Tin can is difficult to seal however and pop can's dont have a wide enough opening.
Its why i was also asking about plastic containers and if those could hold
HIM101 OP t1_j5473pm wrote
Reply to comment by MacsGPPDisorder in What container for DIY pressure pot for 5-10 PSI by HIM101
Thing is i cant fit my mold through a bottle opening, and for mason jar im a little worried about if it does go wrong the glass would explode out. Would something like covering the sides with a blanket help with that?
HIM101 OP t1_j546t5j wrote
Reply to comment by MacsGPPDisorder in What container for DIY pressure pot for 5-10 PSI by HIM101
I was intending to use a valve and pump from a bike wheel. Thats what they did in the tutorial and it seems like it should work fine since the pressure shouls be fairly low.
And also as that should hopefully clear up im not trying to make a vaccuum, im trying to add pressure.
HIM101 OP t1_j54ekwv wrote
Reply to comment by rampampwobble in What container for DIY pressure pot for 5-10 PSI by HIM101
Getting the pressure isnt the problem. Im mostly wondering what the best containers would be for it.