[removed]
Comments
[deleted] t1_j6fxxix wrote
[deleted]
PJ505 t1_j6fxz82 wrote
Appliance dolly.
FLTDI t1_j6g00ku wrote
And beer for said friend
[deleted] t1_j6g0i3k wrote
[removed]
Spinaccio t1_j6g0st7 wrote
Did you drain it? Water heaters are mostly air when they’re empty. That said borrow or rent a furniture/appliance dolly.
Bldaz t1_j6g12fu wrote
Might be filled with calcium crack that drain off
uncle_cousin t1_j6g18qd wrote
Ours was just too heavy to get upstairs so we decided to chop it up in place. Turned out to half full of fine sand that must have added at least 200 lbs to the weight.
warlocktx t1_j6g1uhj wrote
Stupid question, but have you drained it? An empty water heater shouldnt be that heavy. Unless it’s filled with sediment, which happens to my parents because they’re on well water
[deleted] t1_j6g1uwp wrote
[removed]
[deleted] t1_j6g1xli wrote
[removed]
culb77 t1_j6g2fxj wrote
Unless you’re doing something else with it, there’s no reason for it to still be in one piece. Take off anything you can to make it lighter.
[deleted] t1_j6g2p1o wrote
[removed]
Capital-Ebb-2278 t1_j6g2q0j wrote
The first time I replaced a water heater I drained it but the sediment kept it from draining and it was probably half full of water. When I went to move it I grabbed the top and tried to lift it out and it just leaned over and almost fell on top of me. I punched out the drain and let the rest of the water drain out, then it was simple to move. Be careful!
[deleted] t1_j6g2rso wrote
[removed]
kivuli t1_j6g33sl wrote
I like the forearm forklifts. I use them every time I help someone move or move appliances.
They sell them at a bunch of hardware stores.
[deleted] t1_j6g3ohk wrote
[removed]
NotWorthTheTimeX t1_j6g4r2l wrote
You must have no idea. An 80 gallon hybrid water heater is 281 pounds without water. 80 gallons of water alone weighs 667 pounds. If he hadn’t drained it it would be nearly 1k pounds.
Averen t1_j6g4s9m wrote
Step one make sure it’s out of water
Step two get a hand truck and strap
Step three get one person on handle of hand truck pulling up the steps and one person lifting from the bottom and go one step at a time. Really easy actually
j45780 OP t1_j6g4twu wrote
Can't chop it because I don't have a way to recover the refrigerant.
[deleted] t1_j6g50bu wrote
[deleted]
NotWorthTheTimeX t1_j6g55i5 wrote
This is the answer. An appliance dolly used properly with the straps and two people. One person at the top and one at the bottom. Going slow and steady. It will be out in no time. I feel his pain and once helped install a 50 gallon hybrid water heater.
[deleted] t1_j6g5ac3 wrote
[removed]
PrettyNothing8962 t1_j6g5tn8 wrote
Hire a plumber and have him move it
j45780 OP t1_j6g5xz6 wrote
Yep, it's empty.
j45780 OP t1_j6g65vm wrote
I took a peek with a borescope and there's no buildup.
It's just a heavy unit.
Bldaz t1_j6g6bsg wrote
Sorry man dolly and a bunch of guys
j45780 OP t1_j6g6dfu wrote
I replaced it with a hybrid 50 gallon; it's much lighter.
NotWorthTheTimeX t1_j6g6j8y wrote
Nice!! How many years did your 80 last? The 50 I helped install is about 6 years old now and problem free so far.
NotWorthTheTimeX t1_j6g6w7q wrote
The 50 gallon is only 63 pounds lighter than the 80 (281 vs 218 for Rheem). Still a two person job with stairs.
j45780 OP t1_j6g776s wrote
Wish I could get it repaired. A new one is about $2,900.
j45780 OP t1_j6g7v78 wrote
About 11 years. It has two fault codes: one for low coolant pressure and another one for failed upper element (which i could not budge).
inkseep1 t1_j6g7xuf wrote
You can rent a stairs climbing dolly. They lift the dolly on each step so you don't have to.
Scoobywagon t1_j6g8660 wrote
Preferably a 2 wheel dolly with stair rollers. IF you don't have a friend, a couple of ratchet straps (to hold the tank on the dolly) and a come-along (to pull the assembly up the stairs) will work pretty well.
Alternatively, since it has failed, you don't need to worry about getting it up the stairs in one piece. So go after it with a sawzall and work out some hostility.
pnutjam t1_j6g8dhl wrote
You can probably rent an electric stair climbing dolly at your local tool rental place. Call around. They are heavy, but make it a one person job.
RetroGamer87 t1_j6g8fdr wrote
First, drain the water 💦
j45780 OP t1_j6gd2y2 wrote
An 80 gallon AO Smith hybrid water heater is 280# empty.
CanadianBaconMTL t1_j6gdnip wrote
open window and yeet, or dolly
EthanWS6 t1_j6gdqik wrote
Cutting it up is a good idea too
Spinaccio t1_j6gffoh wrote
God to know, thanks.
chrisinator9393 t1_j6gggn2 wrote
If you really need this thing out of your basement & are doing it on your own property, just chop it up. The quantity of refrigerant in one unit isn't a big deal.
ThreeBlurryDecades t1_j6ggvvz wrote
Refrigerant? Isnt this a water heater?
chopsuwe t1_j6gkjvw wrote
Your submission has been removed for one or more of the following reason(s):
- Your question does not include the research you've done to find an answer yourself, or why that research didn't answer your question.
This is a basic requirement so others do not spend time repeating your steps. It is not a judgement about your question being "too easy." We're looking for evidence that you've made an attempt yourself.
-
Please do not use /r/DIY as your first stop for questions - we are not Google.
-
Please search Google and /r/DIY to see if your question has been asked before. Check owners manuals, tech support forums or contact the manufacturer.
-
Have you already done some basic research and are still stuck?
-
Please include what research you have done in your question so that others do not repeat your steps.
-
Consider posting your question in the sticky thread at the top of the subreddit.
-
Ask your question in our Discord server in the appropriate channel.
Please read our Full Sub Rules before resubmitting.
If you believe this was a mistake, please message the moderators.
###Do not respond to this comment - you will not receive a response.
Lopsided_Web5432 t1_j6gtowd wrote
Drain it and get yourself a furniture moving trolley
EthanWS6 t1_j6fxx5t wrote
2 wheel dolly and a friend.