Spicy bite with nacho cheese from 7-11 and tall boy peeber

I saw 94° heat with no strips at the registers on a 12° morning after about 15 minutes run time. Wish I had put one in my house but I didn’t want to be a Guinea pig

To the best of my knowledge it’s still not quite there but you’d be hard pressed to see a ROI on geothermal these days. Check out what Bosh has to offer. Their 20 SEER equipment is nuts

It’s been 14 years or so since I’ve laid a hand on one and even then they were pricey. I can’t imagine today

Most of the bigger companies handle it. Green Air does on the smaller side of things. It’s going to be stupid expensive compared to some of the super high efficiency heat pumps that are available nowadays.

You’re supposed to just throw them in the river I think

Ronnie’s

You will get stabbed at least every day

Keep it that way if you value your money

When you charge people $15000 to replace a water heater you can do nice things like this.

You must not be from around here if youre just now realizing this sub is full of self righteous shitbirds

No keto for me. They are however nice for us sweetbloods since they have 0 carbs

They’re unbelievable. I got 2 bags figuring they’d last me a couple days while on the way to Ocracoke. Finished one bag before we made it to the ferry.

Time for a road trip I suppose

I glanced at the thumbnail and thought it was the guy at the tattoo shop in front of Kroger

Hoping it doesn’t go that far. Good to know though

As luck would have it work is sending me to Yorktown tomorrow. They were nice enough to put it on hold for me. Good looking out.

So I’ve managed to stuff a good portion of a blue shop towel into the hole for that purpose and to keep the liberal amounts of pb blaster I’ve soaked it with out. Got that base covered

Worst case scenario I have to get fancy with a hacksaw blade. That’s what a lot of guys on YouTube did

That’s where one of my orders is. Hoping it’s true and I’m just being antsy. Amazon has it showing being delivered tomorrow but it hasn’t shipped and I ordered it Monday

I’m trying my damndest not to pull the intake. What napas have machine shop? Didn’t know that was a thing

That’s not that far from me tbh. It didn’t pop up when I was searching

Only basic nipple extractors which I’ve tried but they’re turning the broken part into mud. This is such a common problem on GM stuff that a special tool exists for it from what I gather